DMSInstallationLiquid ControLs GroupAn IDEX Fluid & Metering BusinessOperation: EM200-10
10Grounding the DMSAfter the DMS is mounted, you must ensure that the DMS is properly grounded. Without a proper ground, the DMS is susceptible to dam
11GROUNDING THE DMS GROUNDING THE TRUCK SEATStatic electricity can build up on truck seats and the drivers themselves, especially during cold, dry wea
12GROUNDINGAIR CUSHION SEAT - ADJUSTABLE FOR HEIGHT(BOSTROM 914 SERIES SEAT OR EQUIVALENT)AIR CUSHION SEAT - ADJUSTABLE FOR HEIGHT(DURA-FORM SEATS OR
13DMS & LectroCount RegistersConnecting the DMS and a LectroCount register(s) together for data communication requires some minor rewiring on the
14DATA CONECTIONS81920 LECTROCOUNT CPU BOARD84040 LECTROCOUNT CPU BOARDData CableVIOLETREDVIOLETREDMove jumper to 485 positionIf using protocol switch
15DMS Lap PadThe DMS lap pad connects to the DMS via the attached, coiled cable. The DB-9 connector plugs into the port labeled “LAP PAD” on the front
16Electronic Registration Power - DMSThe DMS can supply power to one, two, or three LectroCount registers.To supply power to LectroCount register(s) t
17POWER INSTALLATION Do not apply power to the DMS Module until the LectroCount Register has been rewired for RS-485 communication. Refer to page 13 f
18BILL OF MATERIALSOptional Items (not shown)Description Part NumberDMS Power Cable 81973DMS Printer Power Cable 81233DMS Lap Pad E4040USB Memory Devi
19Optional Items (not shown)Description Part NumberInternal Printer Power Supply 81962Auxiliary 1 Cable 81966Auxiliary 2 Cable 81966Meter 2 Cable 8196
2TABLE OF CONTENTS INTRODUCTIONSafety Procedures ... 3DMS System Overview ...
© 2006 Liquid ControlsPub. No. 500343 (11/13)105 Albrecht DriveLake Bluff, IL 60044-22421.800.458.5262 • 847.295.1050Fax: 847.295.1057www.lcmeter.comT
3! WARNINGSAFETY PROCEDURESBefore disassembly of any meter or accessory component: ALL INTERNAL PRESSURES MUST BE RELIEVED AND ALL LIQUID DRAINED FROM
4DMS SYSTEM COMPONENTSDMS, Lap Pad, and Printer on Mounting BracketsGeneral InformationThe DMS is a data management system designed for fuel delivery
5M-10 Meter with LectroCount LCR-II Electronic Register, Optical Air Eliminator, Hi Capacity Strainer, and E-7 Valve.DMS and Lap PadEpson PrintersUSB
6SPECIFICATIONSDMS Module DMS Lap PadHousing • Lightweight, high impact, molded plasticHousing Rating • NEMA 3, IP54Display • LCD, dot matrix, 240
7DIMENSIONSFronttopterminals, ports, and ConneCtions
8Installation Overview This manual assumes a meter system and an LCR-II Lectrocount register is installed on the truck. Only the physical and electric
9Mounting the DMSThe DMS is shipped mounted to the support brackets. There are four B⁄zn" holes drilled into the base of the support brackets for
Comments to this Manuals